A small chimney stack rebuilt and re-flaunched in Salford
A Salford chimney stack with moss and a fern growing from the top, rebuilt and re-flaunched. Photographs of the work.
Flaunching is the sloped mortar at the top of a chimney that holds the pots and sheds rain. It takes a lot of weather, and when it cracks the stack soon feels the effects.
Flaunching, sometimes called the chimney crown, is the mortar bed that surrounds the base of each pot. It does two jobs. It holds the pot firmly in place, and it forms a gentle slope so rain runs off the top of the stack instead of soaking in.
A good flaunching is dense, smooth and slightly overhangs the brickwork so water drips clear. A poor or cracked one lets water into the top of the stack, where it can reach the brickwork and the flue.
Once the flaunching breaks up, the pot can loosen and the brickwork underneath begins to take on water.
From the ground, you may see grey crumbling mortar around pots, pieces on the roof below or gaps where the pot meets the stack. Damp patches or staining on the chimney breast inside can also point to a failed crown. A close inspection from a safe platform will show how bad it is.
If the flaunching is only slightly damaged, loose material is cleared and a fresh layer applied. More often the old flaunching is broken away completely so the top of the stack can be checked. Pots are lifted or steadied, the brickwork cleaned and the bed prepared.
New mortar is then built up around each pot and shaped into a smooth fillet, falling away from the pot on all sides. It should be firmly bonded to the brick and pot, free of cracks, and finished to shed water. Where pots are replaced or re-bedded, that happens as part of the same job.
If the brickwork at the top of the stack is crumbling, repairing the flaunching alone will not hold. The stack may need repointing, or the top courses rebuilt. A cracked or porous pot is also better replaced than re-bedded.
It is common to see flaunching fail on one pot while the others still look reasonable. Even so, it is usually sensible to inspect every pot on the stack while access is in place. Renewing all the crown work together gives a consistent finish and avoids having to set up access again in a year or two.
If your chimney pots are sitting in crumbling mortar, Apex Roofing can inspect the stack and give a free quotation. Call to discuss what is needed.
Call or message Apex Roofing for a free quotation.
It is the mortar fillet around the base of a chimney pot. It secures the pot and slopes to shed rainwater away from the flue and brickwork.
Small areas of damage may be patched, but failing flaunching is usually broken away and renewed so the new mortar bonds properly to a sound base.
Yes. Water entering at the top of the stack can work down through the brickwork and show up as damp on the chimney breast or in rooms below.
Real jobs photographed by Apex Roofing.
A Salford chimney stack with moss and a fern growing from the top, rebuilt and re-flaunched. Photographs of the work.
Ridge and hip repointing, chimney leadwork made good and both pots re-bedded on a Blackpool house. Photographs of each stage of the work.
Mossy mortar raked out of a stone-slated roof in Warrington. The chimney cow was re-bedded and the flaunching renewed, then the whole ridge line was re-pointed.
Apex Roofing covers Cheshire and the surrounding area. Choose your town for local information.
Apex Roofing Cheshire · 5 Weybridge Close, Warrington WA4 5LZ
Tell us about the property and what you have noticed and we will come back to you.
Prefer to talk? Call 07377 461095 · WhatsApp +44 7465 861265 · Email apexroofing14@gmail.com